Pre Milling Unit

This unit available in Minifix 4600/Expert 3600. Provides the proper process of two pieces ball blade; improperly cut slat, MDF, melamine coated chipboard with hopping, jointly and separate operational features. Pre Milling Unit Carries out pre-milling of the panel using large diameter mills mounted on high frequency motors.

Glue Spreading Unit

This unit available in all series. Pre-Melting System it comprises of hot-melt glue melting and spreading and operating independent from pallet. For heat control, 2 pieces thermostat and 2 pieces steel cracker heated. The Glue Unit has a rapid heating System which reduces machine preparation time. It is auto glue unit, glue spreads on panel as per requirement.

Rolling and cutting unit

This unit available in all series.Step Motor Pvc Driver cutting & pulling system has the capacity of cutting the edge banding materials up to 10 mm thickness and 50 mm height. It does not require any adjustment in change over from thin material to thick material.

2 Rollers

This unit available in all series. The proximity switch and plc controlled pneumatic system comprises of 3 rollers. Being gripping drive, the initial pressing carries out pressing setting automatically. This is the only machine that does not apply pressure to the over plus that are in front and rear part of the material to be glued.

Top Surface Cutting

This unit available in all series. Start, end and upper processing system which is easy to use, single movement with single blade, can process on the 3 faces of part and does not give harm to the part on the nodular steel cast chassis. The diameter of the blade is 42 mm. It automatically carries out the passes of prependicular corner soft, post and flat parts from 0.40 mm up to 2 mm. The connection which eliminates the problem of distortion of settings due to heating up, the system which vacuums dust and sawdust, working with 1800 d/min velocity external air-cooled 300 Hz motors

Bottom Surface Cutting

This unit available in all series. Start, end and sub processing system which is easy to use, single movement with single blade, can process on the 3 faces of part and does not give harm to the part on the nodular steel cast chassis. The diameter of the blade is 42 mm. It automatically carries out the passes of prependicular corner soft, post and flat parts from 0.40 mm up to 2 mm. The connection which eliminates the problem of distortion of settings due to heating up, the system which vacuums dust and sawdust, working with 1800 d/min velocity external air-cooled 300 Hz motors

Scraping Group

Available in all series. It is the only scraping unit which is independent from each other, upper and lower radius, pneumatic and does not lead to blockage, by-pass. Can carry out automatic adjustment from 0.40 mm upto 2 mm. Glue scrapper removes any resifual glue which remains on panel board

Polish Group

Available in all series. It carries out the glazing and polishing the banding surface with the help of solvents, two separate 1500 d/min motors.

Grooving With Angled Jumping

This unit available only in Minifix 4600 & Expert 3600. Sloped jumping input-output distance can be adjusted from plc colored touch screen. The diameter of saw is 80*4 mm(ops)

PUR Glue Unit

NC Control System