"Edge Banding
Without Compromise."
Expert 2300 is a entry level Auto Edge Bander. It has end cutting unit with high frequency motor to excess the edge. This machine is suitable for flat cutting operation. Expert 2300 Edge banding machine has ergonomic structure and the fastest, shortest and easy to be used. The smart element of the machine is its compact design.
| Model | Expert 2300 |
|---|---|
| Electric leve | 415-220/50 hz |
| Nominal current | 18 A |
| Edge material thickness | 0.4-2mm |
| Board thickness | 10-50mm |
| Speed | 12 m/min |
| Total electrical power | 4kw |
| Total air pressure | 6 Bar |
| Total air usage | 160 Lt/min. |
| Buffing motor | 2x0.18kw/1310rpm |
| Glue boiler engine | 0.18kwx900rpm |
| Trimming | 2x0.75kw/18000rpm |
| Pallet Motors | 1.1kw/900rpm |
| Machine length | 2300mm |
| Machine width | 800mm |
| Machine height | 1500mm |
Technical
specification
"We Serve What
You Looking For"
Glue Spreading Unit
This unit available in all series. Pre-Melting System it comprises of hot-melt glue melting and spreading and operating independent from pallet. For heat control, 2 pieces thermostat and 2 pieces steel cracker heated. The Glue Unit has a rapid heating System which reduces machine preparation time. It is auto glue unit, glue spreads on panel as per requirement.
Rolling and cutting unit
This unit available in all series.Step Motor Pvc Driver cutting & pulling system has the capacity of cutting the edge banding materials up to 10 mm thickness and 50 mm height. It does not require any adjustment in change over from thin material to thick material.
2 Rollers
This unit available in all series. The proximity switch and plc controlled pneumatic system comprises of 3 rollers. Being gripping drive, the initial pressing carries out pressing setting automatically. This is the only machine that does not apply pressure to the over plus that are in front and rear part of the material to be glued.
Top Surface Cutting
This unit available in all series. Start, end and upper processing system which is easy to use, single movement with single blade, can process on the 3 faces of part and does not give harm to the part on the nodular steel cast chassis. The diameter of the blade is 42 mm. It automatically carries out the passes of prependicular corner soft, post and flat parts from 0.40 mm up to 2 mm. The connection which eliminates the problem of distortion of settings due to heating up, the system which vacuums dust and sawdust, working with 1800 d/min velocity external air-cooled 300 Hz motors
Bottom Surface Cutting
This unit available in all series. Start, end and sub processing system which is easy to use, single movement with single blade, can process on the 3 faces of part and does not give harm to the part on the nodular steel cast chassis. The diameter of the blade is 42 mm. It automatically carries out the passes of prependicular corner soft, post and flat parts from 0.40 mm up to 2 mm. The connection which eliminates the problem of distortion of settings due to heating up, the system which vacuums dust and sawdust, working with 1800 d/min velocity external air-cooled 300 Hz motors
Polish Group
Available in all series. It carries out the glazing and polishing the banding surface with the help of solvents, two separate 1500 d/min motors.
Note: Technical specifications may be changed without any prior notice. Product images are just for the reference.